Spoiler Programme - Nussbaum WA 780 Betriebsanleitung

SPOILER PROGRAMME

This programme enables angle measure-
ment even on vehicles equipped with
especially low spoilers which block meas-
urement of the front and/or rear transverse
goniometer. If this condition occurs, before
displaying the "Rear axle measurement
and registration screen" on the monitor,
the usual error screen will appear (Figs.
30-31-32) with an indication of the inhibited
measurements.
98
The following conditions may occur:
1. Rear spoiler, fig. 31
The user may:
- press F3 key
not be possible to calculate the rear axle
set back;
- select the "Procedura Spoiler posteriore"
("Rear Spoiler Procedure") option form the
F11
2. Front spoiler, fig. 30
The user may:
- press F3 key
not be possible to calculate the front axle
setback;
- select the "Procedura Spoiler anteriore"
("Front Spoiler Procedure") option form the
30
F11
3. Front and rear spoilers, fig. 32.
It is necessary to select the "Procedura
Spoiler anteriore" ("Front Spoiler Proce-
dure") or "Procedura Spoiler posteriore"
("Rear Spoiler Procedure") option from the
31
F11
The user may choose to perform the
spoiler programme on the rear axle or on
the front axle.
The spoiler programme must be carried
out, following the prompts displayed on
the screen, as described below:
32
User Manual WA 780 - Cura S 780
to continue. It will
menu.
to continue. It will
menu.
menu.