Main Working Elements Of The Machine; Central Unit; Radio Communication Measuring Sensors - Nussbaum WA 780 Betriebsanleitung

MAIN WORKING
ELEMENTS OF THE
MACHINE
WARNING
Get to know your machine.
The best way to prevent accidents and
obtain top performance from the ma-
chine is to ensure that all operators
know how the machine works. Learn the
function and location of all commands.
Carefully check that all controls on the
machine are working properly. To avoid
accidents and injury, the machine must
be installed properly, correctly oper-
ated and regularly serviced.

CENTRAL UNIT

1) Monitor
2) Printer
3) Personal Computer
4) Keypad
5) Measuring sensors
6) Measuring sensors compartment
7) Monitor stand
5
76
RADIO COMMUNICATION
The measuring sensors (fig. 17) of this
aligner do not require any cables or cords
because they have been designed using
the latest CCD technology.
The angles are measured by means of 8
CCD goniometers and the data are trans-
mitted from the measuring sensors to the
central unit by means of radio-frequency
devices.
Each measuring sensor is equipped with
rechargeable batteries which, when fully
charged, can operate for approximately 8
hours.
Batteries can be charged by simply
connecting the measuring sensors to the
central unit with a cable. In order to avoid
running down the battery, the measuring
sensors automatically switch off after
approximately five minutes of inactivity
(the automatic switch-off time depends
on the conditions in which the measuring
sensors are not used, as explained in
the "Measuring sensors" section below),
keeping in memory the data calculated
up until that time.
At the time of the automatic switch-off a
beeper is sounded to alert the operator.
Each measuring sensor must be posi-
7
1
2
3
MEASURING SENSORS
8
4
User Manual WA 780 - Cura S 780
6
17