Data Input Window; Chassis Height Screen - Nussbaum WA 780 Betriebsanleitung

DATA INPUT WINDOW

The data input windows refer to:
- Vehicle makes in databank;
- Models of vehicle in databank;
- Customers on file;
- Vehicles on file;
- Operators on file.
To enter the data, proceed as follows:
- select the field to be modified using the
"Tab" or "Shift" + "Tab"keys (if the window
contains more than one field)
- enter a character/value
To confirm the data entered and exit this
window, proceed as follows:
- press the F3 key; you will be prompted
to confirm saving of the data.
- press F3 to confirm,
If you do not wish to confirm saving, press
F2.
When entering a new item, the system prompts
the user with data for a similar vehicle to simplify
the entry of the tolerance data.
Remarks
The data for a new customer and/or a new
vehicle can also be entered at the end of
the measurement and adjustment proce-
dure of a model chosen from the vehicle
databank.
In the printing window, a message prompt-
ing the input of data will appear when
saving of data on request or in automatic
mode has been set in the set-up. In the
print window select the data input window
from the F11
90
menu.
CHASSIS HEIGHT
SCREEN
After ROC has been performed, if the se-
lected vehicle requires certain databank
values to be varied as a function of the
height of the chassis at specific points, the
chassis clearance window is displayed.
The operator must select the height val-
ues on the displayed tables, which most
closely match those of the vehicle in
question.
To make the selection, proceed as de-
scribed in the "General considerations" sec-
tion.
In certain cases it is not possible to make
a selection; the displayed height values
are "prescribed" values, i.e. the only cor-
rect references for databank values, to be
achieved if necessary by applying weights
to the vehicle.
The following keys are active in this window:
F1 displays the on-line "Help"
function
F2 goes back to the previous
screen
F3
(or Enter) goes to the next
screen in the established
operating sequence.
F11 displays the menu with
the relative functions.
These are the menu options:
• End of work (Goes back to the starting
screen)
• Operating sequence (recalls the align-
ment execution setting screen, according
to the user's preferences)
• Help (recalls the Help screen relative to
the current screen).
User Manual WA 780 - Cura S 780