Error Screen; Vehicle Make Selection Screen - Nussbaum WA 780 Betriebsanleitung

ERROR SCREEN

The screen shown in figure 22 is displayed
when there is a transmission or measure-
ment error.
In these cases, the cause of the error must
be corrected in order to resume normal
operation.
However, if this is not possible, press the
key from the starting screen to
exit the programme correctly.
Then call in the Technical Support Service.
User Manual WA 780 - Cura S 780
VEHICLE MAKE
SELECTION SCREEN
It allows the user to select the make of the
vehicle using the procedures described in
the "General Considerations" section.
The following keys are active in this screen:
F1
F2
F3
22
F6
F7
F8
F11
These are the menu options:
• End of work (goes back to the starting
screen)
• Set-up (opens the contextual set-up on
the screen where you are)
displays the on-line Help
function
goes back to the previous
screen
(or Enter) confirms a make
selection and goes to the
next screen in the estab-
lished operating sequence
(databank values table, com-
pensation, measurement)
deletes a previously entered
make. This operation is only
possible for models from the
secondary databank
deletes a previously entered
make.
This operation is only pos-
sible for the makes from the
secondary databank if there
are no associated models.
enters a new make (see "En-
ter/Modify window" section)
displays the menu with the
relative functions.
GB
83