Compensation" (Roc) Screen - Nussbaum WA 780 Betriebsanleitung

The following keys are active in this screen:
F1
displays the on-line "Help"
function
F2 (or Esc) halts the anima-
tion or goes back to the
previous screen
F3 (or Enter) starts or replays
the animation
F11 displays the menu with the
relative functions.
These are the menu options:
• Start context (goes back to the starting
screen)
• Help (recalls the Help screen relative to
the current screen).
92
"COMPENSATION"
(ROC) SCREEN
Used to select and execute the compensa-
tion procedure for the rim off-centre and
out-of-true following the mode set by the
selected method.
The following ROC options are available:
• "3-point ROC"
• "Push-mode ROC"
• ROC Skip
• ROC Recall
The following keys are active in this window:
F1 displays the on-line "Help"
function
F2 goes back to the previous
window
F11 displays the menu with the
relative functions.
These are the menu options:
• End of work (goes back to the starting
screen)
• Help (recalls the Help contextual screen
on the screen where you are)
PERFORMING "3-POINT ROC"
1. Lift the vehicle.
2. Check that the wheels (or one wheel) are
able to turn freely and that the measuring
sensors are switched on and not locked.
3. Press the "ROC" key (2, Fig.24) of the
measuring sensor on which you want to
carry out the ROC procedure. An hour-
glass appears on the screen to indicate
the beginning of the measurement; when
the hourglass disappears and the "OK"
message appears on wheel concerned,
the initial position (0°) of that wheel has
been saved in memory.
User Manual WA 780 - Cura S 780