Job Count; Service Procedure Screen - Nussbaum WA 780 Betriebsanleitung

JOB COUNT

This option is visible only if previously ena-
bled in the aligner general set-up.
To access the "Job Count" window, press the
"Ctrl"+"F12" keys, then you will be prompted
for a password that, for security reasons, is not
published in this user manual. If interested
in this option, please request the password
from the support service.
The total count of the jobs performed is
indicated in the bottom section of the two-
section window (Fig. 33). In the top section,
the job count per working day is displayed
together with a calendar from where to choose
a day to be displayed.
Three fields are located above the job count
per working day, where the desired day,
month and/or year can be selected for rapid
selection of the date searched. After setting
the date, confirm the selection by pressing
the "Enter" key
This window behaves like message windows,
where the active function keys are in the
window, whereas the function bar keys are
disabled.
The following keys are active in this window:
F2 goes back to the previous
screen
User Manual WA 780 - Cura S 780
F4
Remarks
When resetting the overall job count to
zero, only the overall count is reset to zero,
while the number of jobs saved every day
is not altered.
SERVICE PROCEDURE
The service window is accessed by selecting
the "Programmi di servizio" ("Service Programmes")
33 option from the F11
aligner programme main window.
A list of the options available is displayed:
• Demo;
• Crooked steering wheels;
• Heads calibration;
• Heads test;
• Technical Assistance.
Select an option and press Enter to access
the procedure chosen.
Select the "Demo" option and press enter
to enable/disable the programme in demo
mode.
Measuring sensors cannot be used in demo
mode, all values displayed are random.
Enabling/disabling of this function is indi-
cated by an icon
right-hand corner of the job window.
resets the overall job count.
SCREEN
menu of the
Demo
in the lower
GB
101