Standard Working Sequence - Corghi EXACT BlackTech X Betriebsanleitung

Eichstädt Elektronik - Professionelle Kfz-Diagnosegeräte
STANDArD worKING
SEQUENCE
Alignment procedure for 2-axle vehicles (cars).
1) Aligner switch-on.
2) Start work.
3) Databank / Job record.
4) Preparation for wheel alignment.
5) wheel diameter input.
6) Compensation.
7) Chassis height input.
8) Angle measurement with steering locked to
10° or 20°.
9) Data summary.
10) Rear axle measurement.
11) Front axle measurement.
12) Angle measurement with steering locked
to 10° or 20°.
13) Front axle measurement.
14) Print out of data measured.
(1) Switching on the aligner
IMPORTANT For the first start-up, the "Monitor
adjustment" chapter must be read.
Turn on the device using the main switch.
wait a few seconds to allow the monitor to switch
on and the computer to load the program.
In this stage, the central unit runs a functional
self-diagnostics test and loads the operating
system; if everything is in order, the "Main menu"
screen will appear (Fig. 33).
If the user set-up field "Alignment customisation
procedure/Lift test" = YES, the programme will
automatically open the "Lift Check" page, see
"Lift and Target Check" section.
(2) work start selection (Fig. 33)
Tilt level selection
Pressing ALT-O you access the page shown in Fig.
66, in which the current operator can be selected
by double clicking on the name.
Some icons are located at the bottom of the
screen that are used to set the camera tilting to
the preset levels:
Tilting reset and positioning to the fac-
tory predefined position.
Tilting positioning in the predefined
position for ROC.
Tilting positioning in the predefined
62
position for the steering lock.
position for the adjustment.
position.
position.
Click on the EXIT icon to return to the initial
page.
Initial page
To access this function from the rest of the pro-
gramme select the
Select the wheel alignment mode
procedure
"demo" mode, for which the targets are not
required. The "demo" mode is indicated by the
maintenance utilities, and wheel aligner cus-
tomisation.
down all the applications open and switches off
the wheel aligner.
http://www.eichstaedt-elektronik.de
Tilting positioning in the predefined
Tilting positioning in the 1st auxiliary
Tilting positioning in the 2nd auxiliary
and start work
restarts the previous job.
and enable and disable the
symbol in the status bar.
and access the service and
ends execution of the program, shuts
Operator's manual EXACT BlackTech X
icon or the F9 key.
and
.