Preparing The Vehicle For The Alignment Operation; Thrust Angle - Corghi EXACT BlackTech X Betriebsanleitung

Eichstädt Elektronik - Professionelle Kfz-Diagnosegeräte
➥ Axis of reference
__ Symmetry: axis of symmetry is axis of refer-
ence for both front and rear.
__ Thrust: thrust axis is axis of reference for both
front and rear. Setting the steering-wheel
with the front half toe values equal ensures
the steering wheel will be straight in normal
operating conditions. If the thrust axis is axis
of reference for the rear axle, the rear half toe
values area always identical.
__ Straight steering wheels: reference axis is
axis of symmetry for rear and thrust axis for
front. Setting the steering-wheel with the front
half toe values equal ensures the steering
wheel will be straight in normal operating
conditions.
➥ Save previous data
__ Automatic: vehicle situation before adjust-
ment is saved automatically.
Manual: vehicle situation before adjustment
is saved manually.
➥ Caster measurement steering lock
__ 20°: Steering always locked to 20° for caster
measurement.
__ User's choice: Caster measurement steering
lock at 10° or 20°.
➥ Front axle adjustment
__ Caster.
__ Total toe – setback.
➥ Rear axle adjustment
__ Total toe – thrust angle.
__ Setback – track difference.

➥ Thrust angle

__ Clockwise positive: angle is positive when
thrust axis is turned clockwise in relation to
the axis of symmetry.
__ Anticlockwise positive: angle is positive when
thrust axis is turned anticlockwise in relation to
the axis of symmetry.
Logo
The logo is the image shown as background in
the "Main Menu" (Fig. 33) and used as three-
dimensional image in the screen saver.
2 customised logos can be entered: they are
selected from the set-up as the "Customised 1"
and "Customised 2" logos.
The customised logo files must be in bitmap
format and must have dimensions of 800x337
pixels.
Save the files in C: \ program files \ alignment \
graphics \ image\.
Operator's manual EXACT BlackTech X
The file for the "Customised 1" logo is LogoFeF.
bmp, for the "Customised 2" logo it is LogoFew.
bmp.
The customer's logo can be added to the printed
job report.
Replace file C:\ Programs Files \Alignment\Graph-
ics\Image\IMGPrBarra4.bmp with an equivalent
containing the logo of your choice.
Warning! The file dimensions must be 1100 x
354 pixels.
PrEPArING THE VEHICLE
For the wheel alignment operation to be carried
out correctly, all parts of the vehicle must conform
to the constructor's specifications; in particular,
it is important to check the tyre pressure and
eliminate any backlashes in the bearings and
ball joints.
Place the vehicle over the pit or on the lift
equipped for the alignment operations, taking
care to ensure that the turntables and oscillating
footboards are locked in position.
Fit the self-centring clamp/target assembly on the
wheels and lock the clamp jaws onto the wheel rim
using one of the two handles. Mount the "vertical"
targets on the front wheels and the "horizontal"
targets on the rear wheels (Fig. 27_B).
Do not over-tighten the clamp as this may
cause it to bend.
http://www.eichstaedt-elektronik.de
Customised logo for printout
For THE ALIGNmENT
oPErATIoN
CAUTION
EN
61