Caster; King Pin; Setback - Corghi EXACT BlackTech X Betriebsanleitung

Eichstädt Elektronik - Professionelle Kfz-Diagnosegeräte
➥ Caster measurement steering lock
__ Always activated: Caster measurement steer-
ing lock always activated.
__ On request: Caster measurement steering
lock activated on request.
__ If adjustable: Caster measurement steering
lock only activated if at least one of the angles
that can be measured is adjustable (caster,
king pin, steering angle difference at 20° and
maximum steering angle).
➥ Rear axle
__ Always activated: Rear axle adjustment always
activated.
__ If adjustable: Rear axle adjustment only ac-
tivated if at least one of the angles that can
be measured is adjustable (half toe, camber,
total toe, setback).
➥ Second steering
__ Always activated: Caster measurement sec-
ond steering lock always activated.
__ Automatic skip: Caster measurement second
steering lock not activated.
__ If adjustable: Caster measurement second
steering lock only activated if at least one of
the angles that can be measured is adjustable
(caster, king pin, steering angle difference at
20° and maximum steering angle).
➥ Measurement assistant
__ YES: The measurement help animations are
shown.
__ No: The measurement help animations are
not shown.
➥ 1/2 axle alignment
__ YES: 1 or 2 axle alignment selection procedure
active.
__ NO: 1 or 2 axle alignment selection procedure
not active.
➥ Data summary
__ Always activated: The data summary is always
displayed.
__ On request: The data summary is only
displayed if activated with the appropriate
icon.
➥ King pin caster
__ YES: The values are calculated and dis-
played.
__ NO: The values are not calculated and dis-
60
➥ Chassis height before ROC
__ YES: The data related to chassis height is
__ NO: The chassis height is entered after
➥ Ask to end the job
__ YES: A confirmation message is displayed if
__ NO: when the end of job icon is pressed, the
➥ Perform ROC
__ Always: ROC is always performed.
__ Manual skip: It is possible to skip the ROC
__ Automatic skip: ROC is always skipped.
➥ Push Mode ROC type
__ Professional: back to 60...then 30 then 0.
_ Standard: 30 - 0.
➥ Cal One-Touch
__ YES: Enables the Cal One-Touch device. Also
__ NO: Disables the Cal One-Touch device.
➥ Steering wheel offset
__ YES: Displays the steering wheel centring
__ NO: Does not display the steering wheel cen-
Wheel aligner
➥ Turntable enabling
__ Always: Electronic turntables for maximum
__ On request: Electronic turntables enabled
__ Never: Electronic turntables for maximum
http://www.eichstaedt-elektronik.de
played.
entered before the ROC phase.
ROC.
the end of job icon is pressed.
starting page will appear and any unsaved
data will be lost.
phase with the appropriate icon.
the connection port and the type of con-
nection should be enabled in the Assistant
Set-up.
control page before the Cal One-Touch ad-
justment.
tring control page before the Cal One-Touch
adjustment.
steering angle always enabled.
with the appropriate icon on the steering
page.
steering angle not enabled.
Operator's manual EXACT BlackTech X