General Functions - Corghi EXACT BlackTech X Betriebsanleitung

Eichstädt Elektronik - Professionelle Kfz-Diagnosegeräte
Programme step recall
Diameter selection Recalls input of the
rim diameter to be used in toe measurements
in millimetres / inches.
Chassis height For vehicles where this
is necessary, recalls input of the chassis heights
necessary to obtain the databank references
Steering angle Recalls the steering lock
procedure for measurement of the caster, king pin,
steering angle difference at 20° and maximum
steering angle.
Data summary Recalls the summary of
the vehicle data.
Front axle Recalls the front axle adjust-
ment step.
Rear axle Recalls the rear axle adjust-
ment step.
Data summary and printout Recalls the
job data summary, printout and save step.
End of session Ends the current job
and returns to the main menu.
Vehicle adjustment Selects the help
function for adjustment of the vehicle. Only the
help selections available are active.
Vehicle selection Recalls selection of
the vehicle from the databank.
Databank data summary Recalls the full
summary vehicle's databank references.
Chassis situation Recalls the vehicle
chassis situation step.
EZShim Recalls the EZShim calcula-
tion program.
Toe curve Recalls the toe curve checking
Operator's manual EXACT BlackTech X
and adjustment procedure.
ment screen for the equipment for adjusting
the Mercedes "Distronic" anti-collision radar
system.
for calibration procedures and other utility
.
programs.
that supplies the estimate of the vehicle's degree
of "dog tracking".
visual checking of the vehicle.
acquiring and adjusting the vehicle's axle weight.
gramme step in the pre-set sequence.
gramme step.
gramme step without requiring execution of the
current step.
sor from the icon bar to the working zone.
selected object (for example, it increases the
rim diameter to the value above).
selected object (for example, it decreases the
rim diameter to the value below).
http://www.eichstaedt-elektronik.de
Distronic Adjustment Recalls the align-
Log Recalls the logs screen. Active
Chassis misalignment Recalls the screen
Visual check Recalls the procedure for
Vehicle weight Recalls the procedure for

General functions

Continue Moves on to the next pro-
Last step Returns to the previous pro-
Skip operation Skips to the next pro-
Back to selection Moves the active cur-
Increase Increases the value of the
Decrease Decreases the value of the
Exit Ends the current operation.
EN
51