Installation; Assembling The Equipment - Corghi EXACT BlackTech X Betriebsanleitung

Eichstädt Elektronik - Professionelle Kfz-Diagnosegeräte

INSTALLATIoN

WARNING
Carry out the unpacking, assembly, lifting and
installation operations described with care.
Failure to comply with these instructions could
damage the machine and put the operator
at risk.

Assembling the equipment

- Unpack the equipment, placing the packaging
in the position shown by the markings on it.
- Remove the monitor from its packaging (Fig.
3).
- Fit the monitor in its position (A, Fig. 4)
threading the power supply and signal cables
through the specific slot (B, Fig. 4); secure the
monitor base with the specific clamp (C, Fig. 4)
and lock everything with the screws supplied
with the aligner (D, Fig. 4). If a monitor with a
very small base is used, use also the adapter
supplied with the aligner.
- Remove the rear panel of the lower cabinet.
- Take the aligner Sim Card (Fig. 52) and remove
it from its profiled support (keep the Sim Card
support, with serial number, for any future
enquiries) and fit it into the slot provided
(A, Fig. 53 with box open) with the gilded
contacts facing downwards and the chamfer
towards the outside of the reader (B, Fig.
53). Replace the front panel. The reader can
be fixed underneath the PC shelf (A, Fig. 54)
using the threaded rivets (B, Fig. 51) and the
screws provided, or it can be installed above
the PC later (B, Fig. 54).
- Unpack the personal computer (Fig. 6).
- Through the front door, place the computer
on the top shelf (Fig. 7).
For correct positioning, place the front part
of the computer level with the front of the
shelf.
- Remove the printer from its packaging (A, Fig.
8), place it in the drawer of the cabinet (B, Fig.
8) and connect the power supply and data
cables (C, Fig. 8), after passing them through
the holes in the drawer (D, Fig. 8).
- Connect the cables with the aid of the wiring
diagram (Fig. 55); all the plugs are clearly
marked on their respective PC sockets. Press
the plugs fully down without applying too
much force, and tighten the safety screws
Operator's manual EXACT BlackTech X
- The aligner is supplied set to operate with a
- Replace the rear door using the spanner pro-
- Only for aligners equipped with "USBAI". The
- Connect the power supply cable to the plug
- Turn on the aligner with the main switch and
- Update the wheel aligner software if neces-
For additional information about the technical
characteristics, warnings, maintenance and any
other data about the monitor or the printer,
read the relative operator's manuals supplied
with machine documentation.
http://www.eichstaedt-elektronik.de
where present (Fig. 9). Connect the flat cable
of the remote control to the 25-pole D-Sub-
connector marked "REMOTE" of the reader
(A, Fig. 54c).
Note the differences in wiring, depending on
whether the smart card reader is installed in-
side or outside the PC, as illustrated below.
230 Vac power supply. The aligner can be set
to operate with a mains voltage of 115 Vac.
vided.
wheel aligner card supplied has already been
fitted in the Sim Card slot.
provided; first read the "Electrical Hook-up"
section.
the monitor and the printer with the specific
switches.
sary, "Updating the wheel Aligner Software"
section, and install any optional kits, "Installing
Additional Functions" section.
CAUTION
EN
43