D) Basic Information Relevant To The Control Of Model Helicopters - Reely Ice Tiger Bedienungsanleitung

• Now the 4 position lights start to blink and the receiver/
controller module (1) performs an internal matching
operation for approx. 2 seconds.
An LED attached to the bottom of the fuselage tip blinks
during this process.
The helicopter must not be moved during this time.
• Once matching is complete, the two servo engines (also
see ill. 15, pos. 1 and 2) of the rotor control also move
to neutral (center position) and the control LED is
permanently green.
If the control LED changes from green to red during flight, you have to charge your model
immediately to prevent damaging deep discharging of the flight accumulator.
For illustration purposes, the cabin hood was removed for the illustration (also see fiigure 14).
Attention important!
Before starting to fly your model helicopter, you should take note of the following information
first.

d) Basic information relevant to the control of model helicopters

Before you fly your model, you should first familiarize yourself with the control possibilities open to you and thereby be
able to fly safely. The double rotor model helicopter is controlled via the two control sticks at the remote control
transmitter. The following functions are available:
Pitch Function
With the Pitch function you can control the flying height of the helicopter (see figure 7, Pos.A). The control is effected
with the left control stick (see figure 1, Pos. 12). To that effect, the control stick can be moved forward and backward.
Unlike with other control functions, .the stick does not keep springing back to the centre position.
As the angles of attack of the rotor blades are not modifiable, setting the flying height is effected via a common speed
modification of the two rotors.
• Pulling the control stick towards you switches off the motors and the rotors stop.
• If you push the control stick forward, the rotors run and increase the speed according to the position of the stick.
• When the control stick reaches the centre position, the helicopter should hover.
44
Figure 6