B) Checking The Retainer Of The Rotor Blade; C) Connecting The Flight Battery - Reely Ice Tiger Bedienungsanleitung

b) Checking the retainer of the rotor blade

• To allow the 4 rotor blades (1) to orientate themselves
at a 180° angle to each other during operation, the
screws of the 4 blade retainers (2) must not be too firmly
tightened.
• If you pitch the model helicopter by 90° to the side, the
rotor blades must be able to let slightly downward as
illustrated in the figure.
c) Connecting the flight accumulator
• Push the charged flight accumulator (1) according to
the figure, from the back into the battery shaft (2) on
the bottom of the fuselage,
The accumulator's connection cable must point
backwards in flight direction.
In order to achieve the correct balance, the accumulator
may not protrude beyond the accumulator support.
• Pull out the transmitter antenna completely and turn on
the transmitter. Slide the left control stick to the bottom
position (see ill. 1, pos. 12, engine-off position).
• Now you can connect the flight accumulator with the
help of the BEC connection, which is protected against
wrong polarity on the receiver/controller element of the
helicopter. The triple-pole charge cable is not connected
with the model.
Figure 4
Figure 5
43