Practical Flight Tips For The First Start - Reely Ice Tiger Bedienungsanleitung

• After successful conversion and adjustment of the
retention force, you have to detach the two connection
cables (1) of the control potentiometers by soldering
them off and solder them on again in reverse order.
In any case, observe the correct connection sequence
of the coloured wires.
• Then reinsert the circuit board with the master/slave
socket and screw the back wall back on.
• Finally, perform a function control of the entire system.
If you want different function assignments for the control stick than the default factory settings but are
not in a position to carry this out yourself, you can send the transmitter in to our customer service
department in Hirschau.
Our technicians will convert the remote control to suit your requirements and you will be billed for this
work.
f) Practical flight tips for the first start
• Even if the model can fly in the narrowest spaces, for the first test flights, we recommend using a free space of about
3 x 3 m.
• The support should be flat (tiles, parquet flooring, or similar) to allow you to determine already before the take off if
the model tends to drift off in a particular direction.
• Place yourself exactly behind your helicopter. As long as you can see your model from behind, the latter will react to
the control commands: right, left, forward, backward exactly as you see it. Whereas, if the cockpit of the model
points towards you, it reacts exactly the opposite way from your steering commands at the transmitter.
48
Figure 9