Charging Rechargeable Batteries In The Transmitter - Reely Ice Tiger Bedienungsanleitung

c) Charging Rechargeable Batteries in the Transmitter
When using the remote transmitter with accumulators, you can attach a charging cable to the charging jack (7 in Fig.
1) while the transmitter is switched off to charge the accumulators with a suitable charger (not part of the delivery)
directly in the transmitter.
Warning!
The provided power pack unit only serves to supply the LiPo charger with power and is not
suited to charge the transmitter accumulators.
When connecting a charge cable, imperatively observe the correct polarity of the connecting plug. The inner contact of
the charge socket has to be connected to the plus connection (+) and the outside contact to the minus connection (-)
of the charger.
The charging current should be approx. 1/10 of the capacity value of the inserted rechargeable batteries. For
rechargeable batteries with a capacity of 2000 mAh, the charging current will be approximately 200 mA and the
charging time about 14 h. To prevent damage to the internal circuitry and connections, do not use a fast battery
recharger.
Connect the charger only if the rechargeable batteries (1.2V/cell) have been inserted in the transmitter.
Never try to recharge batteries (1.5V/cells) with a charger. There is a risk of fire and explosion!
When the rechargeable batteries have been recharged or new batteries have been inserted, pull out the antenna of
the transmitter all the way and, turn on the transmitter with the function switch (see figure 1, pos. 5) for test purposes.
The green LED display (see Figure 1, pos. 8) indicates the power supply of the transmitter.
If the power supply is not sufficient any more for faultless operation, the LEDn colour switches to yellow. In this case,
you should stop operating your model as quickly as possible. If the voltage drops below 7.5 V, the LED colour turns
red. For further operation of the transmitter the rechargeable batteries have to be recharged or new batteries have to
be inserted.
In order to avoid the memory effect of NiCd rechargeable batteries, you should connect the charger only when the
rechargeable batteries are completely discharged.
41