B) Adjusting The Rotor Blade Control - Reely Ice Tiger Bedienungsanleitung

b) Setting the steering mechanism
• The top rotor is controlled via the paddle rod with
govenor weights.
The bottom rotor blades are controlled via two separa-
te servo engines.
The left servo engine (seen in flight direction, 1) is in
charge of the roll function (also see ill. 7, C).
The right servo engine (seen in flight direction, 2) is in
charge of the nod function (also see ill. 7, D).
• If the helicopter shows a strong trend to fly to a certain direction and if the trimming function on the transmitter is not
sufficient for a correction, you can influence the flight behaviour of the helicopter by changing the installation points
on the control disks to make it fly in the right direction.
• In general, select the attachment spots in such a way that the rotor shaft runs centrally through the central piece (3).
The trimming lever on the transmitter should be in central position in this case.
For a better display, the rear part of the body was detached from the helicopter in ill. 15 and 16.
Disassembly was done analog to the cabin hood.
54
Figure 15