Technical Specifications; Properties Of Your Design Espresso Pro - Gastroback DESIGN ESPRESSO PRO Bedienungsanleitung

tical position, then press the POWER button), before emptying the
drip tray. Otherwise, due to the backflush system of the appliance hot
water could run out.

TECHNICAL SPECIFICATIONS

Model:
Power supply:
Maximum power consump-
tion:
Length of power cord:
Weight:
Dimensions:
Capacity of water tank:
Maximum Pressure:
Certificate:
These specifications may change without notice.

PROPERTIES OF YOUR DESIGN ESPRESSO PRO

Your new »DESIGN ESPRESSO PRO« Machine is designed for brewing coffee, tex-
turing and heating milk, giving off hot water for any type of water-based hot drinks,
for diluting your coffee, and for pre-heating cups and the portafilter.
Typically the espresso grind is somewhat finer than that designated for other types
of coffee brewers. Fill the coffee powder in the designated, double-walled stainless
steel filter basket, distribute it evenly and tamper it. Thereafter you install the filter bas-
ket at the group head of the machine via a pressure-tight portafilter. The 1000 W
Thermoblock heating system will bring the water to the required brewing temperature.
The 15 bar Ulka pump forces the water through the coffee powder on high pressure.
Already after some seconds, the espresso will drip from the portafilter spouts. You
control the desired amount of espresso according to your likings, via the brewing
time. If you prefer espresso pads, the special E.S.E. pad system (Easy Serving Espres-
Art.-Nr. 42709 »Design Espresso Pro«
220 - 240 V AC, 50 - 60 Hz, 10 A
1000 W
approx. 100 cm
approx. 5.1 kg
approx. 240 x 274 x 318 mm
(W x D x H)
MIN: approx. 0.1 Liter (100 ml; 1 Tasse)
MAX: approx. 1.5 Liter
15 bar (Ulka-Pumpe)
55