Inserting Batteries (Or Rechargeable Batteries) In The Transmitter; E) Turning The Transmitter On; F) Connecting The Rechargeable Battery Pack; Activating The Control Unit - Reely X-Cellerator Bedienungsanleitung

d) Inserting Batteries (or Rechargeable Batteries) in the Transmitter
If you have not done so already, insert the rechargeable battery/batteries into the transmitter. Please observe correct
polarity (plus/+ and minus/-).
e) Switching on Transmitter
Turn the transmitter on before connecting the rechargeable battery pack with the drive control.
If required, check its display (LC display) to see whether the inserted rechargeable batteries/batteries are still fully
charged.

f) Connecting the Rechargeable Battery Pack

Prior to connecting the rechargeable battery pack to the control unit, activate the remote control transmitter (see
chapter 8d) and 8e).
To prevent a sudden starting of the wheels and therefore an
uncontrolled starting of the model (e.g. if the trimming for
the drive is maladjusted), place the model vehicle on a
suitable cardboard box (1), so that the wheels can turn freely
in case there is a fault.
Now connect the rechargeable battery pack to the drive
control.
g) Activating the Control Unit
Place the transmitter gas/brake lever in the neutral position
and move the control unit switch (see circle in illustration on
the right) to the "ON" position. It is possible that the switch is
placed on another position on the vehicle.
Wait a few seconds until the LED on the control unit is
continuously lit red.
Now check the drive and steering function of the vehicle.
If necessary, adjustments can be made to the settings with
the help of the control unit and transmitter operating
instructions, e.g. trimming the steering on the transmitter or
programming of the control unit on the transmitter
(positioning of full acceleration, neutral, reverse).
30
Figure 3
Figure 4