H) Mounting And Fastening The Car Body; I) Steering The Vehicle - Reely X-Cellerator Bedienungsanleitung

h) Mounting and Fastening the Car Body

Guide the tube of the antenna from underneath the car body through the hole intended for that purpose.
Now put the car body on the holders and fasten the vehicle lining with the safety clips removed at the start.
Your car is now ready for its first test run.

i) Steering the Vehicle

Operate the throttle for the drive function very cautiously and do not drive too fast at the beginning until
you get used to the reactions of the car. Never switch the transmitter off while the vehicle is being
driven!
Do not make quick jerky movements on the controls (levers etc) of the remote control.
If the vehicle shows a tendency to pull towards the left or the right, set the steering trim on the transmitter
accordingly.
When changing between going forward and reverse, the throttle has to be briefly (approx. 1 second) in
the centre position (centre position = motor not moving).
When the throttle is directly pushed from forward to reverse, the brake function of the drive is activated
(vehicle will NOT reverse).
Examples:
1. Release throttle, vehicle rolls to a halt (or doesn't
move).
2.Drive forwards, slowly pull the throttle towards
the handle
3.Going forward and then braking (vehicle
decelerates; does not roll slowly to a halt); slide
throttle rapidly away from the handle
4.Going forward and then reverse (wait briefly
between directions!)
Wait briefly
31