Inserting The Accumulator Pack In The Vehicle; Inserting Accumulators (Or Rechargeable Batteries) In The Transmitter; E) Turning The Transmitter On - Reely Hotlander Next Generation Bedienungsanleitung

c) Inserting the accumulator pack in the vehicle
Pull off the two safety clips (1) and then lift the attachment
rod off by pulling it upwards (2).
Insert the accumulator pack into the chassis; the connection
cable should point towards the rear axis to not hinder the
steering mechanics.
Reinsert the attachment strut in the right orientation and
attach it with the previously removed safety clips.
Experienced drivers may even use 7-cell accumulator packs.
For this purpose, remove the rear attachment bolt (4), which
is secured with a screw from the bottom. Afterwards, reinsert
it in the rear chassis boring (5).
Attention!
The accumulator pack must not yet be connected to the cruise control/receiver.
d) Inserting accumulators (or rechargeable batteries) in the transmitter
If you have not done so already, insert the accumulator/batteries into the transmitter. Please observe correct polarity
(plus/+ and minus/-).
e) Switching on Transmitter
Turn the transmitter on before connecting the accumulator pack with the drive control.
If required, check its display (LC display or LED) to see whether the inserted accumulators/batteries are still fully
charged.
30
Figure 3
Figure 4