Starting Operation; A) Removing The Car Body; B) Installing The Receiver's Antenna Cable; Inserting The Rechargeable Battery Pack In The Vehicle - Reely The Crawler Bedienungsanleitung



8. Starting Operation

a) Removing the car body

The car body is secured with four holding clips which must be pulled out from the retaining stubs. The car body can
then be taken off.

b) Installing the receiver's antenna cable

The receiver's antenna cable is normally coiled in the vehicle
as delivered.
Uncoil the antenna cable completely and smoothen it
carefully.
Now insert the antenna cable from below through the
attachment (1).
Guide it through the antenna tube (2) and plug the antenna
tube into the attachment.
If a rubber cap is enclosed for the antenna tube, it prevents
the dislocation of the cable after attachment on the tip.
c) Inserting the rechargeable battery pack in the vehicle
The battery pack is inserted in the lower holder such that its
connection cable points to the rear of the vehicle.
Swing the rear axle upwards far enough to allow the
rechargeable battery pack to be inserted in the battery
compartment.
The rechargeable battery pack can be attached using cable
ties.
Note!
The rechargeable battery pack must not yet
be connected to the control unit/receiver.
d) Inserting batteries (or rechargeable batteries) in the transmitter
If you have not done so already, insert the rechargeable battery/batteries into the transmitter. Please observe correct
polarity (plus/+ and minus/-).
26
Figure 1
Figure 2