C) Replacing The Linkage Rods - Reely SKY I-Helicopter Bedienungsanleitung

c) Replacing the Linkage Rods

The linkage rods (1) can be removed from the linkage balls
(2) with suitable long-nosed pliers or tweezers.
Work particularly carefully so that the linkage rods with the
linkage balls will not break.
Attention!
When attaching the spare linkage rods, ensure
that the side with the smaller bores is on the
outside and the slightly larger bores are pressed
over the ball.
Regularly check all screw connections of your helicopter for tight fit. All moving parts have to be easily movable but
there should not be a clearance in the bearing.
When replacing mechanical parts use only original spares available from the manufacturer.
The spare parts list is located on our website www.conrad.com in the download section to the respective product.
You can also order the replacement parts list by phone. For contact information, please refer to chapter "1. Introduction"
at the beginning of these operating instructions.
40
Figure 16