Restore Factory Settings; C) Deleting All Detector Addresses; D) Resetting Factory Settings - Conrad Electronic Rm50 Bedienungsanleitung


Please note:
No addresses are deleted or changed on changing batteries (irrespective of whether in
smoke detector or in alarm dialler). The address data remain intact. It is therefore not
necessary to re-register the smoke detector.
c) Deleting all sensor addresses
Deletion of all sensor addresses may be necessary if the address memory of the alarm dialler is full
(e.g. due to test registrations). You can follow the same procedure, if old smoke detector addresses
no longer used are to be deleted.

A complete new registration of the smoke detectors pertaining to the system is then
needed.
1. Activate programming mode
• Press "Prg" key
• Red LED "Mode" lights up, entry level 1 is active
2. Select "Add" mode
• Press key "Mod" , then press key "2"
• Now all sensor addresses are deleted.
• The red LED "Mode" goes off, the programming mode is terminated and the alarm dialler returns
to the normal operation
d) Restore factory settings
Resetting the alarm dialler to factory settings deletes all settings made (except the texts in the speech
memory).
1. Activate programming mode
• Press "Prg" key
• "Mode" LED lights up, entry level 1 is active
2. Select "Factory settings" mode
• Press key "Mod" , then press "*" key (Star symbol)
• Now all settings are deleted.
• The red LED "Mode" goes off, the programming mode is terminated and the alarm dialler returns
to the normal operation.
56