Functioning Tests; A) Checking The Voice Message; B) Test Call - Conrad Electronic Rm50 Bedienungsanleitung

8. Functioning tests

a) Checking the voice message

After recording, the voice message can of course be heard back and checked. A built-in loudspeaker
is provided for this purpose.
1. Selecting and playing back the message
• Press "Voc" key
• Select voice message (key "1" for smoke alarm or key "4" for battery run down warning)
• The saved message is played back
2. Terminating/ aborting the playback
• The playback stops automatically at the end of the voice message. The playback can be aborted
manually by pressing any key.

b) Test call

You can make a test call to check if the programming of the telephone numbers is correct and also
the proper connection with the telephone network.

Inform the called person beforehand and this is only a test call so that s/he receives the
call and listens to the voice message. On a test call, only the voice message for the smoke
alarm is played back.
1. Starting the test call
• Press "No." key
• Select the telephone memory location number (press key "1", "2" or "3" )
• The telephone number of the selected memory location is dialled; the voice message for a
smoke alarm is played back.

While the test call is being made, you cannot naturally use the connected telephone.
2. Terminate the test call
• The call ends automatically at the end of the message. The call is interrupted by pressing any
key.
51