Static Route Setup Screen - ZyXEL NBG4115 Bedienungsanleitung

15.2.1 Static Route Setup Screen

To edit a static route, click the edit icon under Modify. The following screen
displays. Fill in the required information for each static route.
Figure 79 Management > Static Route > IP Static Route: Static Route Setup
The following table describes the labels in this screen.
Table 54 Management > Static Route > IP Static Route: Static Route Setup
LABEL
Route Name
Active
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Metric
Apply
Cancel
User's Guide
DESCRIPTION
Enter the name of the IP static route. Leave this field blank to delete
this static route.
This field allows you to activate/deactivate this static route.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a
route to a single host, use a subnet mask of 255.255.255.255 in the
subnet mask field to force the network number to be identical to the
host ID.
Enter the IP subnet mask here.
Enter the IP address of the gateway. The gateway is an immediate
neighbor of your NBG4115 that will forward the packet to the
destination. On the LAN, the gateway must be a router on the same
segment as your NBG4115; over the WAN, the gateway must be the IP
address of one of the Remote Nodes.
Metric represents the "cost" of transmission for routing purposes. IP
routing uses hop count as the measurement of cost, with a minimum of
1 for directly connected networks. Enter a number that approximates
the cost for this link. The number need not be precise, but it must be
between 1 and 15. In practice, 2 or 3 is usually a good number.
Click Apply to save your changes back to the NBG4115.
Click Cancel to return to the previous screen and not save your
changes.
Chapter 15 Static Route
155