Advanced - ZyXEL NBG4115 Bedienungsanleitung

Table 39 Network > WAN > Internet Connection: Mobile 3G
LABEL
Apply
Reset

8.4 Advanced

Use this screen to enable Multicast, allow Windows Networking and enable
Auto-bridge.
Note: The three categories shown in this screen are independent of each other.
To change your NBG4115's advanced WAN settings, click Network > WAN >
Advanced. The screen appears as shown.
Figure 59 Network > WAN > Advanced
The following table describes the labels in this screen.
Table 40 WAN > Advanced
LABEL
Multicast Setup
Multicast
Windows Networking (NetBIOS over TCP/IP)
User's Guide
DESCRIPTION
Click Apply to save your changes back to the NBG4115.
Click Reset to begin configuring this screen afresh.
DESCRIPTION
Check this to enable multicasting. This applies to traffic routed from
the WAN to the LAN.
Leaving this blank may cause incoming traffic to be dropped or sent
to all connected network devices.
Chapter 8 WAN
113