Advanced - ZyXEL NBG4115 Bedienungsanleitung

Chapter 7 Wireless LAN

7.4 Advanced

Click Network > Wireless LAN > Advanced. The screen appears as shown.
Figure 47 Network > Wireless LAN > Advanced
The following table describes the labels in this screen.
Table 31 Network > Wireless LAN > Advanced
LABEL
Wireless Advanced Setup
RTS/CTS
Threshold
Fragmentatio
n Threshold
Beacon
Interval
DTIM
Preamble
92
DESCRIPTION
Data with its frame size larger than this value will perform the RTS
(Request To Send)/CTS (Clear To Send) handshake.
Enter a value between 0 and 2432.
The threshold (number of bytes) for the fragmentation boundary for
directed messages. It is the maximum data fragment size that can be
sent. Enter an even number between 256 and 2346.
This field is not available when Super Mode is selected.
When a wirelessly networked device sends a beacon, it includes with it a
beacon interval. This specifies the time period before the device sends the
beacon again. The interval tells receiving devices on the network how long
they can wait in low-power mode before waking up to handle the beacon.
This value can be set from 20ms to 1000ms. A high value helps save
current consumption of the access point.
Delivery Traffic Indication Message (DTIM) is the time period after which
broadcast and multicast packets are transmitted to mobile clients in the
Active Power Management mode. A high DTIM value can cause clients to
lose connectivity with the network. This value can be set from 1 to 100.
A preamble affects the timing in your wireless network. There are two
preamble modes: long and short. If a device uses a different preamble
mode than the NBG4115 does, it cannot communicate with the NBG4115.
User's Guide