Wpa-Psk/Wpa2-Psk - ZyXEL NBG4115 Bedienungsanleitung

Table 28 Network > Wireless LAN > General: Static WEP
LABEL
Hex
Key 1 to Key
4
Apply
Reset

7.2.3 WPA-PSK/WPA2-PSK

Click Network > Wireless LAN to display the General screen. Select WPA-PSK
or WPA2-PSK from the Security Mode list.
Figure 45 Network > Wireless LAN > General: WPA-PSK/WPA2-PSK
User's Guide
DESCRIPTION
Select this option in order to enter hexadecimal characters as a WEP key.
The preceding "0x", that identifies a hexadecimal key, is entered
automatically.
The WEP keys are used to encrypt data. Both the NBG4115 and the
wireless stations must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10
hexadecimal characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26
hexadecimal characters ("0-9", "A-F").
You must configure at least one key, only one key can be activated at any
one time. The default key is key 1.
Click Apply to save your changes back to the NBG4115.
Click Reset to reload the previous configuration for this screen.
Chapter 7 Wireless LAN
89