Wps Station - ZyXEL NBG4115 Bedienungsanleitung

Chapter 7 Wireless LAN
Table 33 WPS
LABEL
Apply
Refresh

7.7 WPS Station

Use this screen when you want to add a wireless station using WPS. To open this
screen, click Network > Wireless LAN > WPS Station tab.
Note: Note: After you click Push Button on this screen, you have to press a similar
button in the wireless station utility within 2 minutes. To add the second wireless
station, you have to press these buttons on both device and the wireless station
again after the first 2 minutes.
Figure 51 WPS Station
The following table describes the labels in this screen.
Table 34 WPS Station
LABEL
Push Button
Or input
station's PIN
number
98
DESCRIPTION
Click Apply to save your changes back to the NBG4115.
Click Refresh to get this screen information afresh.
DESCRIPTION
Use this button when you use the PBC (Push Button Configuration)
method to configure wireless stations's wireless settings. See
6.4.1 on page 68.
Click this to start WPS-aware wireless station scanning and the wireless
security information synchronization.
Use this button when you use the PIN Configuration method to
configure wireless station's wireless settings. See
70.
Type the same PIN number generated in the wireless station's utility.
Then click Start to associate to each other and perform the wireless
security information synchronization.
Section
Section 6.4.2 on page
User's Guide