Internet Access - ZyXEL NBG4115 Bedienungsanleitung

Chapter 24 Troubleshooting
• If your computer is connected to the WAN port or is connected wirelessly, use a
computer that is connected to a LAN/ETHERNET port.
I can see the Login screen, but I cannot log in to the NBG4115.
Make sure you have entered the password correctly. The default password is
1
1234. This field is case-sensitive, so make sure [Caps Lock] is not on.
You cannot log in to the Web Configurator while someone is using Telnet to access
2
the NBG4115. Log out of the NBG4115 in the other session, or ask the person who
is logged in to log out.
This can happen when you fail to log out properly from your last session. Try
3
logging in again after 5 minutes.
Disconnect and re-connect the power adaptor or cord to the NBG4115.
4
If this does not work, you have to reset the device to its factory defaults. See
5
Section 24.5 on page

24.4 Internet Access

I cannot access the Internet.
Check the hardware connections, and make sure the LEDs are behaving as
1
expected. See the Quick Start Guide.
Make sure you entered your ISP account information correctly in the wizard. These
2
fields are case-sensitive, so make sure [Caps Lock] is not on.
If you are trying to access the Internet wirelessly, make sure the wireless settings
3
in the wireless client are the same as the settings in the AP.
• Go to Network > Wireless LAN > General > WDS and check if the NBG4115 is
set to bridge mode. Select Disable and try to connect to the Internet again.
Disconnect all the cables from your device, and follow the directions in the Quick
4
Start Guide again.
Go to Maintenance > Sys OP Mode > General. Check your System Operation Mode
5
setting.
204
206.
User's Guide