Wlan And Maintenance Settings - ZyXEL NBG4115 Bedienungsanleitung

Chapter 5 AP Mode
Note: If you change the IP address of the NBG4115 in the screen below, you will need
to log into the NBG4115 again using the new IP address.
Figure 28 Network > LAN > IP
The table below describes the labels in the screen.
Table 22 Network > LAN > IP
LABEL
Get from
DHCP Server
User Defined
LAN IP
IP Address
IP Subnet
Mask
Apply
Reset

5.5 WLAN and Maintenance Settings

The configuration of wireless and maintenance settings in AP Mode is the same as
for Router Mode.
• See Chapter 5 on page 69
network.
• See Maintenance and Troubleshooting (179)
your Maintenance settings.
60
DESCRIPTION
Select this to let the DHCP server in the gateway assign the NBG4115 IP
address.
Select this to give the NBG4115 a static IP address.
Type the IP address in dotted decimal notatiion. The default setting is
192.168.1.2. If you change the IP address you will have to log in again
with the new IP address.
The subnet mask specifies the network number portion of an IP address.
Your NBG4115 will automatically calculate the subnet mask based on the
IP address that you assign. Unless you are implementing subnetting, use
the subnet mask computed by the NBG4115.
Click Apply to save your changes to the NBG4115.
Click Reset to reload the previous configuration for this screen.
for information on the configuring your wireless
for information on the configuring
User's Guide