Advanced - ZyXEL NBG4115 Bedienungsanleitung

The following table describes the labels in this screen.
Table 55 Management > Bandwidth MGMT > General
LABEL
Service Management
Bandwidth
Management
Type
Total Bandwidth Setting. The fields below appear when you enable Bandwidth
Management.
Uplink
Downlink
Apply
Reset

16.3 Advanced

Use this screen to configure bandwidth managements rule for the pre-defined
services or applications.
Use this screen to configure bandwidth managements rule for specific protocols on
an IP or IP range.
Note: This screen contains the Priority Queue and Bandwidth Allocation tables.
Though both tables are described in this section, you can only apply the rules in
one table. Fill out the table of the Bandwidth Management Type you selected
in Section 16.2 on page 158
User's Guide
DESCRIPTION
This field allows you to have NBG4115 apply bandwidth management.
Select Priority Queue or Bandwidth Allocation to enable
bandwidth management.
Select Priority Queue to allocate bandwidth based on the pre-defined
priority assigned to an application. Refer to
Select Bandwidth Allocation allocate specific amounts of bandwidth
to specific protocols on an IP or IP range. Refer to
page 159.
Select Disable if you do not want to use this feature.
Select the total amount of bandwidth (from 64 Kilobits to 30 Megabits)
that you want to dedicate to uplink traffic.
This is traffic from LAN/WLAN to WAN.
Select the total amount of bandwidth (from 64 Kilobits to 30 Megabits)
that you want to dedicate to uplink traffic.
This is traffic from WAN to LAN/WLAN.
Click Apply to save your customized settings.
Click Reset to begin configuring this screen afresh.
Chapter 16 Bandwidth Management
Section 16.3 on page
Section 16.3 on
159.
159