ZyXEL NBG4115 Bedienungsanleitung Seite 110

Chapter 8 WAN
Table 38 Network > WAN > Internet Connection: PPTP
LABEL
Password
Retype to Confirm
Nailed-up
Connection
Idle Timeout
PPTP Configuration
Server IP Address/
Domain
Connection ID/
Name
Get automatically
from ISP
Use Fixed IP
Address
My WAN IP
Address
My IP Subnet
Mask
WAN IP Address Assignment
Get automatically
from ISP
DNS Servers
First DNS Server
Second DNS Server
WAN MAC Address
Factory default
110
DESCRIPTION
Type the password associated with the User Name above.
Type your password again to make sure that you have entered is
correctly.
Select Nailed-Up Connection if you do not want the connection to
time out.
This value specifies the time in minutes that elapses before the
NBG4115 automatically disconnects from the PPTP server.
Type the IP address of the PPTP server.
Type your identification name for the PPTP server.
Select this option If your ISP did not assign you a fixed IP address.
This is the default selection.
Select this option If the ISP assigned a fixed IP address.
Enter your WAN IP address in this field if you selected Use Fixed IP
Address.
Your NBG4115 will automatically calculate the subnet mask based
on the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the NBG4115.
Select this to get your WAN IP address from your ISP.
Select From ISP if your ISP dynamically assigns DNS server
information (and the NBG4115's WAN IP address). The field to the
right displays the (read-only) DNS server IP address that the ISP
assigns.
Select User-Defined if you have the IP address of a DNS server.
Enter the DNS server's IP address in the field to the right. If you
chose User-Defined, but leave the IP address set to 0.0.0.0, User-
Defined changes to None after you click Apply. If you set a second
choice to User-Defined, and enter the same IP address, the
second User-Defined changes to None after you click Apply.
Select None if you do not want to configure DNS servers. If you do
not configure a DNS server, you must know the IP address of a
computer in order to access it.
The MAC address section allows users to configure the WAN port's
MAC address by either using the NBG4115's MAC address, copying
the MAC address from a computer on your LAN or manually entering
a MAC address.
Select Factory default to use the factory assigned default MAC
Address.
User's Guide