No Security; Wep Encryption - ZyXEL NBG4115 Bedienungsanleitung

7.2.1 No Security

Select No Security to allow wireless stations to communicate with the access
points without any data encryption.
Note: If you do not enable any wireless security on your NBG4115, your network is
accessible to any wireless networking device that is within range.
Figure 43 Network > Wireless LAN > General: No Security
The following table describes the labels in this screen.
Table 27 Wireless No Security
LABEL
Security
Mode
Apply
Reset

7.2.2 WEP Encryption

WEP encryption scrambles the data transmitted between the wireless stations and
the access points to keep network communications private. It encrypts unicast
and multicast communications in a network. Both the wireless stations and the
access points must use the same WEP key.
Your NBG4115 allows you to configure up to four 64-bit or 128-bit WEP keys but
only one key can be enabled at any one time.
User's Guide
DESCRIPTION
Choose No Security from the drop-down list box.
Click Apply to save your changes back to the NBG4115.
Click Reset to reload the previous configuration for this screen.
Chapter 7 Wireless LAN
87