Ip Static Route - ZyXEL NBG4115 Bedienungsanleitung

Chapter 15 Static Route

15.2 IP Static Route

Use this screen to view existing static route rules. Click Management > Static
Route to open the IP Static Route screen. The following screen displays.
Figure 78 Management > Static Route > IP Static Route
The following table describes the labels in this screen.
Table 53 Management > Static Route > IP Static Route
LABEL
#
Name
Active
Destination
Gateway
Modify
154
DESCRIPTION
This is the index number of an individual static route. The first entry is
for the default route and not editable.
This is the name that describes or identifies this route.
This icon is turned on when this static route is active.
Click the Edit icon under Modify and select the Active checkbox in the
Static Route Setup screen to enable the static route. Clear the
checkbox to disable this static route without having to delete the entry.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number.
This is the IP address of the gateway. The gateway is an immediate
neighbor of your NBG4115 that will forward the packet to the
destination. On the LAN, the gateway must be a router on the same
segment as your NBG4115; over the WAN, the gateway must be the IP
address of one of the remote nodes.
Click the Edit icon to open the static route setup screen. Modify a static
route or create a new static route in the Static Route Setup screen.
Click the Remove icon to delete a static route.
User's Guide