Inhaltsverzeichnis
Werbung
Chapter 5 AP Mode
To set your NBG4115 to AP Mode, go to Maintenance > Sys OP Mode >
2
General and select Access Point.
Figure 25 Maintenance > Sys OP Mode > General
A pop-up appears providing information on this mode. Click OK in the pop-up
3
message window. (See
pop-up.) Click Apply. Your NBG4115 is now in AP Mode.
Note: You have to log in to the Web Configurator again when you change modes.
5.3 The Status Screen in AP Mode
Click on Status. The screen below shows the status screen in AP Mode.
Figure 26 Status: AP Mode
56
Section 22.2 on page 196
for more information on the
User's Guide
Werbung
Inhaltsverzeichnis
Fehlerbehebung
