General - ZyXEL NBG4115 Bedienungsanleitung

Chapter 10 DHCP Server

10.2 General

Use this screen to enable the DHCP server. Click Network > DHCP Server. The
following screen displays.
Figure 62 Network > DHCP Server > General
The following table describes the labels in this screen.
Table 42 Network > DHCP Server > General
LABEL
Enable DHCP
Server
IP Pool Starting
Address
Pool Size
Apply
Reset
120
DESCRIPTION
Enable or Disable DHCP for LAN.
DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC
2132) allows individual clients (computers) to obtain TCP/IP
configuration at startup from a server. Leave the Enable DHCP
Server check box selected unless your ISP instructs you to do
otherwise. Clear it to disable the NBG4115 acting as a DHCP server.
When configured as a server, the NBG4115 provides TCP/IP
configuration for the clients. If not, DHCP service is disabled and
you must have another DHCP server on your LAN, or else the
computers must be manually configured. When set as a server, fill in
the following four fields.
This field specifies the first of the contiguous addresses in the IP
address pool for LAN.
This field specifies the size, or count of the IP address pool for LAN.
Click Apply to save your changes back to the NBG4115.
Click Reset to begin configuring this screen afresh.
User's Guide