Preparations And Getting Started; A) Getting Started With The Outdoor Sensor; B) Getting Started With Base Station - Conrad WS 624 Bedienungsanleitung

8. Preparations and Getting Started

Please note:
First insert the batteries in the outdoor sensor, and afterwards into the
base station.
If you proceed in a different succession it may happen that the base
station does not recognise the outdoor sensor (or only after several
hours, during the daily synchronisation).
If you want to try the product out when you first use it, eg in a room, you should not place the
individual devices (base station, outdoor sensor) directly next to each other. Otherwise there
may be reception problems due to radio interferences. Keep a distance of at least 1m between
the individual devices.
This function test makes sure that later reception problems can be attributed to the arrangement
of base station and outdoor sensor(s).
The range in free field is up to 100m (without any sources of interference, direct view between
outdoor sensor and base station). However, the effectively achievable range in buildings is
approx. a maximum of 20-30m.
Please note chapter "13. Range".

a) Getting started with the outdoor sensor

• Open the battery compartment of the outdoor sensor by un-
screwing the four screws on the back with a suitable screwdriver,
see illustration on the right.
58