Remplacement Des Fusibles - VOLTCRAFT VC-2020 Bedienungsanleitung

Remplacement des fusibles

Respecter impérativement les consignes de sécurité lors du rem-
placement des fusibles !
Veiller à utiliser uniquement les fusibles du type et de l'intensité
du courant nominal spécifiés. Il est interdit d'utiliser des fusibles
réparés ou de ponter le porte-fusible.
Toutes les entrées de mesure sont protégées contre les surcharges. Les douilles
d´entrée „V" et „10A" sont protégées par un fusible fein.
Si vous ne pouvez plus effectuer de mesure, cela signifie que le fusible correspon-
dant doit être remplacé.
Procédez comme suit pour le remplacer le fusible:
- Enlevez tous les câbles de mesure et désactivez le multimètre
- Retirez la gaine caoutchouc du boîtier
- Desserrez les deux vis du boîtier situées au dos et ôtez le couvercle avec précau-
tion.
- Remplacez le fusible fin correspondant par un fusible neuf de type et d´ampérage
identiques (voir illustration sous „Mise en place et remplacement des piles").
VC -2020 F 0,5A / 250V instantané 5 x 20 mm (pour la douille VmA)
F 10A / 250V instantané 5 x 20 mm (pour la douille 10A)
VC -5060 F 250mA / 250V instantané 5 x 20 mm (pour la douille VmA)
F 10A / 250V instantané 6 x 25 mm (pour la douille 10A)
- Refermez avec soin le couvercle du logement des piles.
70
For safety and licensing reasons (CE), unauthorised conversion and/or modification
of the device is not permitted.
Consult suitably qualified staff, if you have doubts about how the appliance operates
or about how to connect it safely.
Measuring instruments and accessories are not toys and have no place in the hands
of children.
The accident prevention regulations of the relevant trade associations for electrical
systems and operating materials are to be observed in commercial institutions.
In schools, training centres, computer and self-help workshops, handling of measur-
ing instruments must be supervised by trained personnel in a responsible manner.
Always make sure before measuring voltages that the measuring instrument is not
set to a current measuring range.
The voltage between any socket of the measuring instrument and the ground may
not be higher than 600V VDC in excess voltage category III.
Take particular care when dealing with voltages exceeding 25V AC or 35V DC! Even
with voltages as low as these, it is possible to receive a life-threatening electric
shock if you touch electric conductors.
Prior to each measurement, check your instrument including its measuring lines for
damage. Never carry out measurements when the protective insulation is damaged
(ripped, torn off etc.).
In order to avoid an electric shock, ensure that you do not touch the connections to be
measured, even indirectly, during measurements.
Do not use the multimeter just before, during or just after an electrical storm (electrical
shock! / high-energy over-voltages!). Please make certain that your hands, shoes,
clothing, the floor, the measuring instrument or the measurement lines switches and
switching parts are absolutely dry.
Do not operate the measuring instrument in areas or unfavourable conditions where
combustible gases, vapours or dust are or may be present.
Avoid operation in the immediate vicinity of:
- strong magnetic or electromagnetic fields
- transmitting aerials or HF generators.
This may falsify the measuring value.
31