Accessories - Kärcher KM 120/150 R P Bedienungsanleitung

Replacing filter case seal
 Lift filter case seal out of groove in the
cover.
 Insert new seal.
Checking drive belt
Danger
The engine requires approx. 3-4 seconds to
come to a standstill once it has been
switched off. During this time, stay well
clear of the working area.
 Turn ignition key to "0" and remove it.
 Open cover and secure it (Diag. 3).
 Check tension of drive belt and V-belt of
the suction blower, also check for wear
or damage.
 Check tension of drive belt and V-belt of
the roller brush also check for wear or
damage.
 Only KM 120/150 R LPG and KM 120/
150 with driver cabin:
Check tension of drive belt and V-belt of
the light machine; also check for wear or
damage.
Check cup seal
 Chek the cup seal at the suction blower
regularly to see that it sits properly.
Replacing electric bulb
 Turn ignition key to "0" and remove it.
 Remove side brush.
 Remove splash guard (1).
 Disconnect plug (2).
 Twist contact plate to one side (3).
 Remove defective bulb (4).
 Insert new bulb.
 Twist contact plate back into original po-
sition.
 Connect plug.
 Mount splash guard.
 Screw on side brush.
Replacing fuses of drive control/ elec-
tronic system
The drive control/electronic system is in-
stalled behind the front panel. To replace a
fuse, the front panel must be removed.
 Loosen screws on both sides of the
panel.
Note
The assignment of fuses is indicated on the
inside of the front panel. Only use fuses
with identical safety ratings.
 Replace defective fuses.
 Replace front panel.
Replacing electrical starter in the engine
room (only KM 120/150 R D)
 Open cover and secure it (Diag. 3).
 Replace defective fuse.

Accessories

Installation set suction hose
 Remove suction hose from holder.
 Suck in the dirt.
 Insert the suction hose in the holder.
Note
After completing the suction, ensure that
the tube of the suction hose lies on the floor
of the holder.
35
English