3. Select the desired item and press
Sets the unit to constant output mode.
(In this case, constant output mode (ETM) is entered.)
The setting contents light steadily for approximately
2 seconds for confirmation.
When you press
, the refresh time settings appear
ENTER
after approximately 2 seconds.
However, if high-speed output mode (FST) is set, this ends
the setting procedure here.
"NON" : Shortest time
"dLy" : Refresh delay time input
4. Select the desired item with the cursor movement keys
.
5. Select the desired item and press
If "NON" is selected, this ends the setting procedure.
If "dLy" is selected, the refresh interval can then input.
Press
.
Input the desired number using
.
ENTER
.
ENTER
.
Main display
Sub-display
(Lights)
↓ (After approx. 2 sec.)
Main display
Sub-display
Main display
Sub-display
97