Sony LZ51-B Bedienungsanleitung Seite 82

"Initial values" and "Setting hints".
The initial values are input to the initial setting items. Therefore, it is not necessary to set all items and operation is possible
simply by setting only the necessary items. (See "BCD initial setting menu configuration" on the previous page.) The "initial
values" and "setting hints" for each setting item are given below.
1 Output request data setting
This sets the value for the BCD data that is output when output request signal DRQ1 to 3 is input. Any one of the current value
(1st axis), current value (2nd axis), current value (addition/subtraction axis), maximum value, minimum value, and peak-to-
peak value. Because this setting can be made for each DRQ input, a total of three types of data can be selected. When using
only one type of output data, set DRQ1 only. See "3-4-3. Output Request Data Setting" (P. 89) for details.
DRQ1:
For individual input:
Current value (addition/
subtraction axis)
For AUTO input: 3 • • • • • • • • • •
DRQ2:
For individual input: Minimum value
For AUTO input: • 5 • • • • • • • • •
DRQ3:
For individual input: Maximum value
For AUTO input: • • 4 • • • • • • • •
80
Output current value of data
Number of
(2)
on addition/subtraction axis?
connected scale
(1)
unit axes?
(Yes)
Only one type of
output data?
(No)
(Yes)
Only two types
of output data?
(No)
(Yes)
(No)
"drq" menu setting is necessary
("d1" setting). (For AUTO input, set
the number in the first digit.)
(Yes)
Is the data to be
"drq" menu setting is necessary
output the
(No) ("d2" setting). (For AUTO input, set
minimum value?
the number in the second digit.)
(Yes)
Is the data to be
"drq" menu setting is necessary
output the
("d3" setting). (For AUTO input, set
(No)
maximum value?
the number in the third digit.)
Setting unnecessary
(Initial value)
Setting unnecessary
(Initial value)
Setting unnecessary
(Initial value)