Sony LZ51-B Bedienungsanleitung Seite 108

Note The time T changes according to conditions. If using 2nd axis input or if a separate unit is connected, conditions are
1
poorer and T
1
• 1-axis input: ....... When only the current data value is displayed and an expansion unit other than LZ51-B is not
• 2-axis input: ....... When the current value and the peak data are displayed, and LZ51-K/LZ51-R are being used:
(3) READY invalid time
The READY invalid time is normally about 50 µs. However, if this time cannot be picked up because it is too short, the time
can be lengthened. (For details on the setting method, see "3-4-5. Output Mode Setting" (P. 96).)
However, if this time is lengthened, the time T
For the shortest time
BCD data
Sign
READY
When the refresh time
is lengthened
BCD data
Sign
READY
106
is longer. If linear compensation is input, the processing time required also results in T
being used:
T
1
Valid
Valid
during which the data that is output is valid is also lengthened.
1
About
µ
70 s
Valid
T
2
The data during this time
is discarded.
being longer.
1
T = about 8ms or more
1
T = about 13ms or more
1
Valid Valid
T
3
Valid
T
1 The held time also
becomes longer.