Sony LZ51-B Bedienungsanleitung Seite 84

4 Power-on output mode setting
This sets the BCD data output conditions for the initial setting mode display when the power is turned on. See "3-4-6. Power-on
Output Setting" (P. 99) for details.
For individual input:
Alarm output
For AUTO input:
• • • • • • • • • 1 •
5 Alarm output status setting
This sets the BCD data output conditions when an alarm state is generated while the count is displayed. See "3-4-7. Alarm
Output Setting" (P. 101) for details.
For individual input: Alarm output
For AUTO input: • • • • • • • • • • 1
Note Stored data may be lost or the settings may have changed. Therefore, be sure to check the setting contents even of
items which do not need to be set to make sure these settings are okay.
82
(Count display)
Are the initial settings
selected for the
display mode after the
LY51 power is turned
on? Is the count
(Initial setting display)
display selected?*
* For details on the LY51 power-on
display modes, refer to the LY51
operation manual.
If an alarm state is
generated, is the
data immediately
prior to the alarm
needed?
(No)
Is data output
while the initial
settings are
(Yes)
displayed?
(No)
(Yes)
Setting unnecessary
(Initial value)
"P.on" menu setting is necessary.
(For AUTO input, set the number in
the tenth digit.)
Setting unnecessary
(Initial value)
"ALM" menu setting is necessary.
(For AUTO input, set the number
in the eleventh digit.)