Output Request Data Setting - Sony LZ51-B Bedienungsanleitung

3-4-3.

Output Request Data Setting

This sets the BCD data that is output when DRQ1 to 3 is input.
Note The unit will not operate correctly if data that does not exist for the input axes of the LY51 is selected.
For example, if the addition/subtraction axis is selected for this item even though only one axis is set for the LY51 input
axis setting, the unit will not operate correctly since there is no second axis. If the LY51 input axis is the addition/
subtraction axis, this item can be either the first axis or the second axis.
Because the BCD connector only has wiring for one type of output data, each type of data selected by this item is output by
switching the DRQ signal inputs. Because the DRQ signal inputs are switched in one at a time, the unit will not operate
normally if multiple DRQ signals are input simultaneously.
In addition, when there is only one type of output data, use DRQ1 for the input, and also set just DRQ1 in the initial settings.
(Continued from 3-4-1 (2).) (P. 85)
1. Select "drq" and press
ENTER
The DRQ setting menu screen appears.
Selects the output request data type.
"d1": DRQ1 request data
"d2": DRQ2 request data
"d3": DRQ3 request data
The selected item flashes.
Initial values: "d1" : Current value
(Addition/subtraction axis)
"d2" : Minimum value
"d3" : Maximum value
2. Select the desired item with the cursor movement keys
.
.
Main display
Sub-display
89