Omron V1000 Handbuch Seite 6

• Observe proper electrostatic discharge procedures (ESD) when handling the
drive and circuit boards.
Failure to comply may result in ESD damage to the drive circuitry.
• Never connect or disconnect the motor from the drive while the drive is
outputting voltage.
Improper equipment sequencing could result in damage to the drive.
• Do not perform a withstand voltage test on any part of the drive.
Failure to comply could result in damage to the sensitive devices within the drive.
• Do not operate damaged equipment.
Failure to comply could result in further damage to the equipment.
Do not connect or operate any equipment with visible damage or missing parts.
• Install adequate branch circuit short circuit protection per applicable codes.
Failure to comply could result in damage to the drive.
The drive is suitable for circuits capable of delivering not more than 100,000 RMS
symmetrical Amperes, 240 Vac maximum (200 V Class) and 480 Vac maximum (400V
Class).
• Do not use unshielded cable for control wiring.
Failure to comply may cause electrical interference resulting in poor system
performance. Use shielded twisted-pair wires and ground the shield to the ground
terminal of the drive.
• Do not allow unqualified personnel to use the product.
Failure to comply could result in damage to the drive or braking circuit.
Carefully review the braking option instruction manual when connecting a braking
option to the drive.
• Do not modify the drive circuitry.
Failure to comply could result in damage to the drive and will void warranty.
Yaskawa is not responsible for modification of the product made by the user. This
product must not be modified.
• Check all the wiring to ensure that all connections are correct after installing the
drive and connecting other devices.
Failure to comply could result in damage to the drive.
• Do not connect unapproved LC or RC interference suppression filters,
capacitors, or overvoltage protection devices to the output of the drive.
Using unapproved filters could result in damage to the drive or motor equipment.
I67E-EN V1000 Quick Start Guide
1 Safety Instructions and General Warnings
NOTICE
Equipment Hazard
5