Omron V1000 Handbuch Seite 20

For Auto-Tuning enter the Auto-Tuning menu and perform the steps shown in the fig-
ure below. The number of name plate data to be entered depends on the selected
type of Auto-Tuning. This example shows Rotational Auto-Tuning.
Drive mode
display
Set up all name
plate data
If Auto-Tuning can not be performed for some reason (no-load operation impossible
etc.), then set up the maximum frequency and voltage in the E1-
and enter the motor data manually into the E2-
NOTICE! The Safe Disable inputs must be closed during Auto-Tuning.
I67E-EN V1000 Quick Start Guide
Enter the Auto-
Tuning Mode
The tuning start
display appears
Select the tuning
method
During the tuning the
DRV LED flashes
parameters.
5 Start Up
After successful tuning
"End" is displayed
parameters
19