B) Mounting The Elevator Unit; C) Inspection Of The Rotor Blade Holder - Reely L400 Bedienungsanleitung

b) Mounting the Elevator Unit

For packaging-technical reasons, the elevator unit (1) is
not pre-installed but loosely enclosed with the model, in-
cluding screws and a matching screwdriver.
Place the unit in the prepared location on the tail boom (2)
according to the adjacent figure and screw it on carefully
from above with the two holding screws.
c) Checking the Rotor Blade Retainer
To allow the two main rotor blades (1) to orient themselves
at a 180° angle to each other during operation, the two
blade retainer screws (2) must not be tightened too firmly.
If you pitch the model helicopter to the side by 90°, the
rotor blades must be able to fold downwards on their own
as illustrated in the figure.
Attention!
Do not loosen the fastening screws too much; if
you do, the tracking of the two rotor blades will
no longer correspond, and the blade tips may
run at different heights.
Figure 6
Figure 7
47