Getting Ready For Driving; A) Charge The Car Battery; B) Insert The Transmitter Batteries; C) Open/Close The Cover - Reely Core Z 4WD RtR Bedienungsanleitung

10. Getting ready for driving

a) Charge the car battery

Important:
• Observe "8. Battery information and safety" on page 24".
• Only use the included charger and cable to charge the battery pack. Disconnect the battery and remove it
from the car before charging.
• USB power source: Before connecting, make sure that the USB power source can deliver sufficient
current, otherwise you may damage the source. Do not use a USB port of a computer, keyboard or USB
hub without a power adapter as the current supplied by these ports is insufficient.
Charger LED(s)
Red
Green
Blinking

b) Insert the transmitter batteries

• Open the battery compartment and insert 2x AA 1.5 V batteries, matching polarities shown inside the compartment.
• Replace the cover.
Use new batteries if the LED blinks slowly after switching it on.

c) Open/close the cover

• The car body is mounted onto body posts
using clips.
• Remove these and gently lift the cover up by
bending at the hinge.
Be careful not damage the LED con-
nection wires when lifting the cover up.
28
Description
Charging
Fully charged
• Disconnect the battery/batteries and charger from the power supply.
• Replace the battery/batteries with new one(s).