C118 Display Shut-Down After Timeout; C119 Pre-Alarm Function - JUMO safetyM TB 08 Betriebsanleitung

7.8

C118 Display shut-down after timeout

Display shut-down
0 inactive
1 active
7.9

C119 Pre-alarm function

The pre-alarm signal is indicated by the KV LED and put out simultaneously on the relay output KV. The switching behavior can
be configured as an absolute value or distance to the limit value (relative).
Pre-alarm function
0 no function
1 Absolute value
2 Distance to the limit value
k
ex-factory
V1.00/EN
Remark
The display is permanently switched on.
Display switches off after timeout and reappears
as soon as a key is pressed.
If an alarm or error message occurs, it is immediately displayed although
the display is shut down.
v
Chapter 14 „Alarm messages"
v
Chapter 15 „Error messages"
Remark
Pre-alarm and LED KV is switched off.
The value for the pre-alarm (UA) is defined fixed and is independent of
the set limit value.
The value for the pre-alarm (UA) automatically changes according to the
set limit value and is above or below the limit value depending on the
switching behavior.
7 Configuration level
29